Automatic selection of ships fails with a large number of ships
from 
Stardock Forums
Stardock Forums
I must have had well over 50 ships when this started happening. I was using a "large" galaxy at the time.
I had them all on manual because they had suddenly (again) developed a mind of their own and started heading
to a single point (all but those in orbit) (subject of another thread already active). I also had autoturn
turned off.
After moving a few ships the program did not select the next unmoved ship. I am not sure what would have
happened if I had pushed the "turn" button and will check the nest time I get to this point in testing. The
TAB key and/or the "find" button successfully located an unmoved ship, however.
Cheers,
Jack
I had them all on manual because they had suddenly (again) developed a mind of their own and started heading
to a single point (all but those in orbit) (subject of another thread already active). I also had autoturn
turned off.
After moving a few ships the program did not select the next unmoved ship. I am not sure what would have
happened if I had pushed the "turn" button and will check the nest time I get to this point in testing. The
TAB key and/or the "find" button successfully located an unmoved ship, however.
Cheers,
Jack